Physical Controllers: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
|||
| Line 11: | Line 11: | ||
The Breadboard, purple wires are for holding in your hands. Capacitor to smooth out the voltage. |
The Breadboard, purple wires are for holding in your hands. Capacitor to smooth out the voltage. |
||
''' |
|||
void setup() { |
|||
// initialize serial communication at 9600 bits per second: |
|||
Serial.begin(9600); |
|||
pinMode(LED_BUILTIN, OUTPUT); |
|||
} |
|||
void loop() { |
|||
// read the input on analog pin 0: |
|||
int sensorValue = analogRead(A0); |
|||
// Convert the analog reading (which goes from 0 - 1023) to a voltage (0 - 5V): |
|||
float voltage = sensorValue * (5.0 / 1023.0); |
|||
// print out the value you read: |
|||
Serial.println(voltage); |
|||
digitalWrite(LED_BUILTIN, HIGH); |
|||
delay(voltage * 10); |
|||
digitalWrite(LED_BUILTIN, LOW); |
|||
delay(voltage * 10); |
|||
} |
|||
''' |
|||
Revision as of 14:59, 1 June 2023
Hand holding sensor
Measure the voltage - could be a chain of humans that hold hands, Arduino measure the voltage and smoothes it out with a capacitor. The LED is just to show the difference in voltage:
The Arduino connects to 5Volts, Ground and Analog 0
The Breadboard, purple wires are for holding in your hands. Capacitor to smooth out the voltage.
void setup() {
// initialize serial communication at 9600 bits per second: Serial.begin(9600); pinMode(LED_BUILTIN, OUTPUT);
}
void loop() {
// read the input on analog pin 0: int sensorValue = analogRead(A0); // Convert the analog reading (which goes from 0 - 1023) to a voltage (0 - 5V): float voltage = sensorValue * (5.0 / 1023.0); // print out the value you read: Serial.println(voltage); digitalWrite(LED_BUILTIN, HIGH); delay(voltage * 10); digitalWrite(LED_BUILTIN, LOW); delay(voltage * 10);
}